The busbar processing machine has three processing units: punching, shearing and folding. The main function is to process copper and aluminum busbars of different specifications. Only the corresponding processing units can be used to cut and punch copper and aluminum bars conveniently and quickly. Hole, flat bending, vertical bending, embossing, flattening, twisting twist, pressing cable joints and other different processing. Today, I will introduce several methods to avoid busbar processing machine burning:
4. Punching station (patented design, imitation must be blamed):
1. The motor of the busbar processing machine should be hygienic.
Use a three-phase four-wire (62) 380V±10%+PE cable and connect it to the incoming line end row of [L1, L2, L3, N (secondary line)] in the distribution box. Attention! It must be grounded! Otherwise, the consequences will be at your own risk!
During the operation of the motor, if dust, water stains and other sundries enter it, a short-circuit medium will be formed, which can destroy the insulation layer of the wire, resulting in a short-circuit between turns, increasing the current, and increasing the temperature to burn and destroy the motor. Because of this, dust, water stains and other debris should be avoided from entering the motor, and the outside of the motor should be cleaned frequently. The cooling state is satisfactory.
9. When changing the opening of the variable lower die, no material is allowed to come into contact with the lower die;
2. Check carefully, listen carefully, and stop immediately if you smell peculiar smell.
In view of the above conditions, before pulling out the old board and replacing the new board, you must read the relevant materials carefully, understand the requirements and operation process, and then proceed to avoid larger problems.
Carefully check the motor for vibration, noise and abnormal smell. When the motor of the busbar processing machine is running, especially the high-power motor, it is necessary to check whether the anchor screws, motor end cover, bearing gland, etc. are loose, and whether the grounding device is reliable, etc. .If it is found that the motor oscillation is intensified, the noise increases and the peculiar smell is revealed, be sure to speed up the shutdown as much as possible, and check the clear end to eliminate the fault.
Adopt plunger structure, small pressure pulsation, long life of gemstone; ensure accurate flow
3. It is necessary to prevent the office current of the motor of the bus processing machine from being too large.
Because the motor is overloaded, the voltage is too low, or the mechanical stagnation of the belt will cause the motor to re-run. Because of this, during the operation of the motor, we should always check whether the transmission is flexible and reliable; the concentricity of the coupling Whether it is standard or not; the flexibility of gear transmission, etc., if it is found to be stuck, the Luan bus processing machine should be stopped immediately to remove the fault and then run.