The busbar processing machine is a kind of advanced processing equipment with a high degree of automation and a complex structure, and is the main point and key equipment of the enterprise. To give full play to the higher benefits of CNC equipment, correct operation and careful maintenance are necessary to ensure the utilization rate of the equipment. The following is an introduction to the problems that should be paid attention to in the use of the busbar processing machine.
1. The operating environment of the busbar processing machine
In order to improve the service life of the busbar processing machine, it is generally required to avoid direct sunlight and other thermal radiation, and avoid places that are too humid, dusty or corrosive gas. Corrosive gases can easily corrode and deteriorate electronic components, resulting in poor contact or short circuit between components, affecting the normal operation of the equipment. The busbar processing machine should be kept away from equipment with large vibration, such as punching machines, forging equipment, etc.
2. Power requirements
In order to avoid the influence of large fluctuation of power supply (greater than ±10%) and possible instantaneous interference signals, busbar processing machines generally use dedicated line power supply (such as a separate channel from the low-voltage power distribution room for CNC machine tools) or add voltage stabilizers, etc. Both can reduce the impact of power quality and electrical interference.
3. Operating procedures
The operating procedures are one of the important measures to ensure the safer operation of the busbar processing machine, and the operator must operate according to the operating procedures. When the machine tool fails, the operator should pay attention to keeping the scene, and truthfully explain the situation before and after the failure to the maintenance personnel, so as to analyze and diagnose the cause of the failure and eliminate it in time. In addition, the busbar processing machine should not be stored for a long time. After purchasing the busbar processing machine, it should be fully utilized, especially in the first year of use, so that the weak links that are prone to failure are exposed as soon as possible, and can be eliminated within the warranty period. When there is no processing task, the busbar processing machine should also be energized regularly. It can be energized 1-2 times a week, and each time it runs dry for about 1 hour, so as to use the heat of the machine tool itself to reduce the humidity in the machine, so that the electronic components will not get wet At the same time, it can also find out whether the battery alarm occurs in time to prevent the loss of system software and parameters.